linkedintwitter
Annuaire  |  Flux RSS  |  Espace presse  |  Wiki IJL  |  Webmail  |  Videos  |    Photos   Articles scientifiques  Articles scientifiques 

Publications: Articles

Annees:  
Toutes :: 2002, ... , 2013, 2014, 2015, 2016
Auteurs:  
Tous :: A, B, C, D, E, F, G, H, I, J, K, L, M, N, O, P, Q, R, S, T, U, V, W, X, Y, Z 
Tous :: D'angelo, ... , Deputier, Derkaoui, DERVISEVIC, ... , D’inca 
Preferences: 
References par page: Mots clefs Voir les resumes
References

Articles:

Hazotte, Claire, Leclerc, Nathalie, Diliberto, Sébastien, Meux, Eric and Lapicque, Francois
Environmental Technology, 36(6):796-805
2015

Resume: The aim of this paper is the characterization of spent NiCd batteries and the characterization of an industrial Black Mass obtained after crushing spent NiCd batteries and physical separation in a treatment plant. The characterization was first performed with five cylindrical NiCd batteries which were manually dismantled. Their characterization includes mass balance of the components, active powders elemental analysis and phase identification by X-ray powder diffraction. Chemical speciation of the two metals was also investigated. For cadmium, speciation was previously developed on solid synthetic samples. In a spent battery, the active powders correspond to about 43% of the battery weight. The other components are the separator and polymeric pieces (5%), the support plates (25%) and the carbon steel external case (27%). The sequential procedure shows that the nickel in the positive powders from the dismantled Ni?Cd batteries is distributed between Ni0 (39.7%), Ni(OH)2 (58.5%) and NiOOH (1.8%). Cadmium in the negative powder is about 99.9% as the Cd(OH)2 form with 0.1% of metal cadmium. In the industrial Black Mass, the distribution of cadmium is the same, whereas the distribution of nickel is Ni0 (46.9%), Ni(OH)2 (43.2%) and NiOOH (9.9%). This material contains also 1.8% cobalt and approx. 1% iron.

Equipe: Département CP2S : Chimie et électrochimie des matériaux

El Hichou, Ahmed, Diliberto, Sébastien and Stein, Nicolas
Surface and Coatings Technology, 270(0):236-242
2015

Mots clefs: Electrodeposition Zinc oxide film Aluminum doping

Resume: Abstract Undoped and aluminum doped zinc oxide thin films were successfully deposited by electrodeposition technique from aqueous solution onto ITO substrates at optimized experimental conditions. The variations of the structural, electrical and optical properties with the doping concentration were investigated. X-ray diffraction analysis showed typical patterns of the hexagonal ZnO structure for both doped and undoped films. The films are single phase and polycrystalline with the (002) preferred orientation. The grain size, texture coefficient and optical band gap values were evaluated for different aluminum salt concentrations. The films, obtained from a 10? 7 M aluminum electrolyte, exhibit the highest crystallographic quality and lowest electrical resistivity of 2 × 10? 4 ?·cm with an energy band gap of 3.35 eV.

Equipe: Département CP2S : Chimie et électrochimie des matériaux

Cette annee / Total:
2 / 411
Exporter au format:
BibTeX, XML