linkedintwitter
Annuaire  |  Flux RSS  |  Espace presse  |  Wiki IJL  |  Webmail  |  Videos  |    Photos   Articles scientifiques  Articles scientifiques 

Publications: Articles

Annees:  
Toutes :: 2003, ... , 2008, 2009, 2010, ... , 2015
Auteurs:  
Tous :: A, B, C, D, E, F, G, H, I, J, K, L, M, N, O, P, Q, R, S, T, U, V, W, X, Y, Z 
Tous :: G., ... , Glad, Gladchenko, Gleize, ... , Guyot 
Preferences: 
References par page: Mots clefs Voir les resumes
References

2015

Articles:

Escande, Vincent, Petit, Eddy, Garoux, Laetitia, Boulanger, Clotilde and Grison, Claude
ACS Sustainable Chemistry & Engineering,
2015

Resume: A novel Mn-derived catalyst was prepared starting from biomass of Mn-hyperaccumulating plants growing on metal-rich soils. Recovery of this biomass as value-added ?ecocatalysts? provides incentives for the development of phytoextraction programs on soils degraded by mining activities. Characterization of the resulting plant-based ?Eco-Mn?? catalyst by inductively coupled plasma mass spectrometry (ICP-MS), X-ray diffraction (XRD), X-ray fluorescence spectrometry (XRF) and X-ray photoelectron spectroscopy (XPS) demonstrated the presence of unusual polymetallic complexes of Mn(II) in the catalyst, along with Fe(III). Incorporation of these species into montmorillonite K10 as solid support provided a supported Eco-Mn? catalyst, whose properties were investigated for alkene epoxidation with H2O2 (30 wt%)/NaHCO3 (0.2 M) as a green terminal oxidizing reagent. The supported Eco-Mn? catalyst demonstrated a high efficiency for styrene epoxidation, with only 0.31 mol% of Mn, a much lower content of Mn than in previously described Mn-derived heterogeneous catalysts. Whereas Fe was also present in the supported Eco-Mn? catalyst, comparison experiments showed that Fe had only a limited role in the catalysis. The water content in the reaction medium had a beneficial effect, increasing the reaction efficiency. The supported Eco-Mn? catalyst was recycled four times without any loss of activity. Comparison of its properties to those of heterogeneous catalysts made by incorporation of commercial MnCl2.4H2O and FeCl3.6H2O highlighted the superior catalytic activity of polymetallic species present in the biosourced catalyst. The substrate scope of the method was extended to various alkenes, including bulky natural products, which were epoxidized with high yields (up to 99%), sometimes much higher than those obtained with already described Mn-derived heterogeneous catalysts. Finally, by simple adjustments of reaction conditions, the method allowed controlled access to aldehydes by oxidative cleavage of various styrene-derived substrates (up to 93% yield). The method thus constitutes a valuable alternative not only to classical epoxidation reagents, but also to oxidative cleavage of styrene-derived molecules, which usually involves toxic and hazardous reagents.

Equipe: Département CP2S : Chimie et électrochimie des matériaux

2014

Articles:

Kandaskalov, D., Fournee, V., Ledieu, J. and Gaudry, E.
JOURNAL OF PHYSICAL CHEMISTRY C, 118(40):23032-23041
2014
ISSN: 1932-7447

Equipe: Département CP2S : Métallurgie et Surfaces

Tournier-Colletta, C., Autes, G., Kierren, B., Bugnon, Ph., Berger, H., Fagot-Revurat, Y., Yazyev, O. V., Grioni, M. and Malterre, D.
PHYSICAL REVIEW B, 89(8)
2014
ISSN: 1098-0121

Equipe: Département P2M : Surfaces et Spectroscopies

Gopman, D.B., Bedau, D., Mangin, S., Fullerton, E.E., Katine, J.A. and Kent, A.D.
Journal of Applied Physics, 115(17)
2014

Equipe: Département P2M : Nanomagnétisme et Electronique de Spin

Villaseca, Sebastian Alarcon, Kandaskalov, Dmytro, Gaudry, Emilie and Armbruester, Marc
ZEITSCHRIFT FUR ANORGANISCHE UND ALLGEMEINE CHEMIE, 640(5, SI):753-759
2014
ISSN: 0044-2313

Equipe: Département CP2S : Métallurgie et Surfaces

Audinot, J. -N., Hamdan, A., Grysan, P., Fleming, Y., Noel, C., Kosior, F., Henrion, G. and Belmonte, T.
SURFACE AND INTERFACE ANALYSIS, 46(1, SI):397-400 Audinot, JN (Reprint Author), Ctr Rech Publ Gabriel Lippmann, SAM Dept, 41 Rue Brill, L-4422 Belvaux, Luxembourg. Audinot, J. -N.; Grysan, P.; Fleming, Y., Ctr Rech Publ Gabriel Lippmann, SAM Dept, L-4422 Belvaux, Luxembourg. Hamdan, A.; Noel, C.; Kosior, F.; Henrion, G.; Belmonte, T., Univ Lorraine, Inst Jean Lamour, CNRS, UMR 7198,CS 50840, F-54011 Nancy, France.
2014
ISSN: 0142-2421

Mots clefs: imaging; combinaison; characterization; plasma; nanosims; 3D

Resume: The discharge between a platinum electrode and different metallic monolayers on a silicon substrate produced sub-micrometric structures. The scanning electron microscope images showed the formation of craters with cones, holes, corona, and other exotic structures. The atomic force microscopy images allowed evaluating the depth and height of these complex structures together with the chemical information as determined by NanoSIMS imaging. The plasma impacts locally removed the mono-layer and the bilayer down to the bare silicon substrate. In order to convert the acquired NanoSIMS images into a true three-dimensional distribution of the analyzed species, the SIMS images are overlapped with the corresponding atomic force microscopy images of the same probed area. This analysis method allows a visualization of a complex 3D structure and helps understand the formation mechanisms of the streamer impact. Copyright (c) 2014 John Wiley & Sons, Ltd.

Equipe: Centre de Compétences : ERMIONE informatique et calcul

Djaziri, S., Renault, P.-O., Le Bourhis, E., Goudeau, Ph., Faurie, D., Geandier, G., Mocuta, C. and Thiaudière, D.
Journal of Applied Physics, 116:093504
2014

Equipe: Département SI2M : Microstructures et Contraintes

Hamdan, A., Noel, C., Ghanbaja, J. and Belmonte, T.
Plasma Chemistry and Plasma Processing, 34:1101-1114
2014

Equipe: Département CP2S : Expériences et Simulations des Plasmas Réactifs - Interaction plasma-surface et Traitement des Surfaces ESPRITS

ZHOU, T., COLIN, M., CANDOLFI, C., Boulanger, C., DAUSCHER, A., Santava, E., HEJTMANEK, J., BARANEK, P., AL RAHAL AL ORABI, R., POTEL, M., Fontaine, B., GOUGEON, P., Gautier, R. and LENOIR, B.
Chemistry of Materials, 26(16):4765-4775
2014

Resume: We present a detailed study of the evolution of the electrical, galvanomagnetic, and thermodynamic properties of polycrystalline AgxMo9Se11 compounds for 3.4 ? x ? 3.8 at low temperatures (2?350 K). In agreement with density functional theory calculations, the collected data show an overall gradual variation in the transport properties from metallic to semiconducting behavior on going from x = 3.4 to 3.8. The results evidence subtle variations in the electronic properties with the Ag content, typified by both positive and negative phonon-drag effects together with thermopower and Hall coefficient of opposite signs. Analysis of the data suggests that these features may be due to peculiarities of the dispersion of the valence bands in the vicinity of the chemical potential. A drastic influence of the Ag content on the thermal transport was evidenced by a pronounced change in the temperature dependence of the specific heat below 10 K. Nonlinearities in the Cp(T3) data are correlated to the concentration of Ag atoms, with an increase in x resulting in a more pronounced departure from a Debye law. The observed behavior mirrors that of ionic conductors, suggesting that AgxMo9Se11 for x ? 3.6 might belong to this class of compounds.

Equipe: Département CP2S : Chimie et électrochimie des matériaux

Altaweel, A., Filipic, G., Gries, T. and Belmonte, T.
Journal of Crystal Growth, 407:17-24
2014

Equipe: Département CP2S : Expériences et Simulations des Plasmas Réactifs - Interaction plasma-surface et Traitement des Surfaces ESPRITS

Page:  
Precedente | 1, 2, 3, 4, 5, 6, ... , 32 | Suivante
Total:
318
Exporter au format:
BibTeX, XML