linkedintwitter
Annuaire  |  Flux RSS  |  Espace presse  |  Wiki IJL  |  Webmail  |  Videos  |    Photos   Articles scientifiques  Articles scientifiques 

Publications: Articles

Annees:  
Toutes :: 2002, ... , 2012, 2013, 2014, ... , 2016
Auteurs:  
Tous :: A, B, C, D, E, F, G, H, I, J, K, L, M, N, O, P, Q, R, S, T, U, V, W, X, Y, Z 
Preferences: 
References par page: Mots clefs Voir les resumes
References

Articles:

Bohra, Murtaza, de Weerd, M. C., Fournee, Vincent, Mandal, R. K., Mukhopadhyay, N. K., Chatterjee, Ratnamala and Sastry, G. V. S.
JOURNAL OF ALLOYS AND COMPOUNDS, 551:274-278
2013
ISSN: 0925-8388

Equipe: Département CP2S : Métallurgie et Surfaces

Walczak, L., Goryl, G., Valbuena, M. A., Vobomik, I., Tejeda, A., Taleb-Ibrahimi, A., Kolodziej, J. J., Segovia, P. and Michel, E. G.
SURFACE SCIENCE, 608:22-30
2013
ISSN: 0039-6028

Equipe: Département P2M : Surfaces et Spectroscopies

Cardenas, Luis, Gutzler, Rico, Lipton-Duffin, Josh, Fu, Chaoying, Brusso, Jaclyn L., Dinca, Laurentiu E., Vondracak, Martin, Fagot-Revurat, Yannick, Malterre, Daniel, Rosei, Federico and Perepichka, Dmitrii F.
CHEMICAL SCIENCE, 4(8):3263-3268
2013
ISSN: 2041-6520

Equipe: Département P2M : Surfaces et Spectroscopies

Hamdan, A., Noel, C., Ghanbaja, J., Migot-Choux, S. and Belmonte, T.
Materials Chemistry and Physics, 142:199-206
2013

Resume: Micro-gap discharges created in heptane between two platinum pin-electrodes produce platinum particles embedded in an amorphous carbon matrix which exhibits a short-range order. The platinum particles can be sorted by size. The largest ones (>100 nm in diameter) are created by emission of droplets from the liquid pool formed when the discharge hits the electrode surface. They are submitted to high stress levels by fast thermal quenching. The smallest ones (<5 nm) are synthesized in the plasma. Nanoparticles with diameters ranging from 10 to 20 nm have structure defects and are synthesized in post-discharge where huge temperature gradients exist. The short-range order observed in carbon extends typically over 3 nm, and it is observed by high-resolution transmission electron microscopy. This ordered structure of carbon (and a fortiori sp(3) bonds which are identified by FTIR analyses) is clearly visible around the smallest nanoparticles and it is likely formed at the same location, i.e. in the plasma. (C) 2013 Elsevier B.V. All rights reserved.

Equipe: Département CP2S : Expériences et Simulations des Plasmas Réactifs - Interaction plasma-surface et Traitement des Surfaces ESPRITS

Gopman, D.B., Bedau, D., Wolf, G., Mangin, S., Fullerton, E.E., Katine, J.A. and Kent, A.D.
Physical Review B - Condensed Matter and Materials Physics, 88(10)
2013

Equipe: Département P2M : Nanomagnétisme et Electronique de Spin

Tournier-Colletta, C., Chaput, L., Tejeda, A., Cardenas, L. A., Kierren, B., Malterre, D., Fagot-Revurat, Y., Le Fèvre, P., Bertran, F. and Taleb-Ibrahimi, A.
APPLIED SURFACE SCIENCE, 267:35-39
2013
ISSN: 0169-4332

Equipe: Département P2M : Surfaces et Spectroscopies

Ochoa, E.A., Droppa, R., Basso, R.L.O., Morales, M., Cucatti, S., Zagonel, L.F., Czerwiec, T., Dos Santos, M.C., Figueroa, C.A. and Alvarez, F.
Materials Chemistry and Physics, 143:116-123
2013

Resume: The low energy (similar to 50-350 eV) noble gases ion bombardment of the steel surface shows that the pre-treatments increase nitrogen diffusion by modifying the outermost structure of the material. The surface microstructure and morphology of the studied samples were characterized by Scanning Electron Microscopy (SEM) and Atomic Force Microscopy (AFM). The crystalline and chemical structures in the outermost layers of the surface were analyzed by grazing angle X-ray diffraction (GAXRD) and photoemission electron spectroscopy (XPS). Temperature effusion studies of the implanted ions are used to elucidate the noble gases site localization in the network. The local compressive stress induced by the nearby iron atoms on the core level electron wave functions of the trapped noble gases are studied by photoemission electron spectroscopy (XPS) and interpreted considering a simple mechanical model. Nano-hardness measurements show the dependence of the material elastic constant on the energy of the implanted noble gases. Although the ion implantation range is about few nanometers, the atomic attrition effect is larger enough to modify the material structure in the range of micrometers. Two material stress zones were detected where the outermost layers shows compressive stress and the underneath layers shows tensile stress. The implanted noble gases can be easily removed by heating. A diffusion model for polycrystalline-phase systems is used in order to discuss the influence of the atomic attrition on the N diffusion coefficient. The concomitant effect of grain refining, stress, and surface texture on the enhancing nitrogen diffusion effect is discussed.

Equipe: Département CP2S : Expériences et Simulations des Plasmas Réactifs - Interaction plasma-surface et Traitement des Surfaces ESPRITS

Armbruester, M., Behrens, M., Foettinger, K., Friedrich, M., Gaudry, E., Matam, S. K. and SHARMA, H. R.
CATALYSIS REVIEWS-SCIENCE AND ENGINEERING, 55(3):289-367
2013
ISSN: 0161-4940

Equipe: Département CP2S : Métallurgie et Surfaces

Lundin, D., Vitelaru, C., Poucques, De, Brenning, N. and Minea., T.
Journal of Physics D: Applied Physics, 46:175201
2013

Resume: A 3D Monte Carlo code (OMEGA) was developed to simulate the transport of sputtered atoms in a magnetron discharge operating in direct current mode. Collisions between the sputtered Ti atoms and the neutral process gas atoms (Ar) were modelled. Spatially resolved simulated velocity distributions of the sputtered particles parallel as well as perpendicular to the cathode surface for different operating pressures were recorded and benchmarked against experimentally obtained profiles using laser-induced fluorescence. New differential (angular and energy-dependent) cross sections for Ti-Ar elastic collisions were thereby obtained, which resulted in good agreement between modelled and experimental results. The differences with respect to commonly used extrapolated Ar-Ar cross sections to describe the Ti-Ar interaction are highlighted and discussed.

Equipe: Département CP2S : Expériences et Simulations des Plasmas Réactifs - Interaction plasma-surface et Traitement des Surfaces ESPRITS

Fagot-Revurat, Y., Tournier-Colletta, C., Chaput, L., Tejeda, A., Cardenas, L., Kierren, B., Malterre, D., Le Fèvre, P., Bertran, F. and Taleb-Ibrahimi, A.
JOURNAL OF PHYSICS-CONDENSED MATTER, 25(9)
2013
ISSN: 0953-8984

Equipe: Département P2M : Surfaces et Spectroscopies

Page:  
Precedente | 1, 2, 3, 4, 5 | Suivante
Cette annee / Total:
50 / 493
Exporter au format:
BibTeX, XML